WAN Interface Setup

This page is used to configure the parameters for Internet network which connects to the WAN port of your Access Point. Here you may change the access method to static IP, DHCP, PPPoE, PPTP<% getInfo("usb3g_comment_start");%>, USB3G<% getInfo("usb3g_comment_end");%> or L2TP by click the item value of WAN Access type.

---

WAN Access Type:	Static IP DHCP Client PPPoE <% getInfo("pptp_comment_start");%> PPTP <% getInfo("pptp_comment_end");%> <% getInfo("l2tp_comment_start");%> L2TP <% getInfo("l2tp_comment_end");%> <% getInfo("usb3g_comment_start");%> USB3G <% getInfo("usb3g_comment_end");%>

IP Address:	">
Subnet Mask:	">
Default Gateway:	">
MTU Size:	"> (1400-1500 bytes)

Host Name:	">
MTU Size:	"> (1400-1492 bytes)

---

The First pppoe info:

User Name:	">
Password:	">
Service Name(AC):	">
Connection Type:
Idle Time:	"> (1-1000 minutes)
MTU Size:	"> (1360-1492 bytes)

Dynamic IP (DHCP)
Static IP
IP Address:	">
Subnet Mask:	">
Default Gateway:	">
Server IP Address:	">
User Name:	">
Password:	">
Connection Type:
Idle Time:	"> (1-1000 minutes)
MTU Size:	"> (1400-1460 bytes)
Request MPPE Encryption       Request MPPC Compression

Dynamic IP (DHCP)
Static IP
IP Address:	">
Subnet Mask:	">
Default Gateway:	">
Server IP Address:	">
User Name:	">
Password:	">
Connection Type:
Idle Time:	"> (1-1000 minutes)
MTU Size:	"> (1400-1460 bytes)

User Name:	">
Password:	">
PIN:	">
APN:	">
Dial Number:	">
Connection Type:	<% getInfo("usb3g_comment_start");%> <% getInfo("usb3g_comment_end");%>
Idle Time:	"> (1-1000 minutes)
MTU Size:	"> (1420-1490 bytes)

Attain DNS Automatically

Set DNS Manually

DNS 1:	>
DNS 2:	>
DNS 3:	>

Clone MAC Address:	>
Enable uPNP
Enable IGMP Proxy
Enable Ping Access on WAN
Enable Web Server Access on WAN
Enable IPsec pass through on VPN connection
Enable PPTP pass through on VPN connection
Enable L2TP pass through on VPN connection
Enable IPv6 pass through on VPN connection