value=0> > > > " value=<% getIndex("regDomain"); %>> " value=<% getInfo("country_str"); %>> > > > > > > > > > > > > > > > This page is used to configure the parameters for wireless LAN clients which may connect to your Access Point. Here you may change wireless encryption settings as well as wireless network parameters.

---

" value="ON" ONCLICK="updateState(document.wlanSetup, wlan_idx)">  Disable Wireless LAN Interface
Country:	" onChange="updateCountry(document.wlanSetup,wlan_idx);updateBand(document.wlanSetup, wlan_idx);updateChan(document.wlanSetup, wlan_idx)">
Band:	" onChange=" should_swap(document.wlanSetup, wlan_idx); updateBand(document.wlanSetup, wlan_idx); Set_onChangeBand(document.wlanSetup, wlan_idx, document.wlanSetup.band<% getIndex("wlan_idx"); %>, document.wlanSetup.band<% getIndex("wlan_idx"); %>.selectedIndex); Set_SSIDbyBand(document.wlanSetup, wlan_idx,document.wlanSetup.band<% getIndex("wlan_idx"); %>, document.wlanSetup.band<% getIndex("wlan_idx"); %>.selectedIndex); swap_mib(document.wlanSetup, wlan_idx);">
Mode:	" onChange="updateMode_basic(document.wlanSetup, wlan_idx)"> <% getModeCombobox(); %>               " onClick="showMultipleAP(document.wlanSetup, '/wlmultipleap.htm')">
Network Type:	" onChange="updateType_basic(document.wlanSetup, wlan_idx)">
SSID:	" size="33" maxlength="32" value="<% getInfo("ssid"); %>">
Channel Width:	" onChange="update_controlsideband(document.wlanSetup, wlan_idx); showtxrate_updated(document.wlanSetup,document.wlanSetup.band<% getIndex("wlan_idx"); %>.options[document.wlanSetup.band<% getIndex("wlan_idx"); %>.selectedIndex].value, wlan_idx, <% getIndex("rf_used"); %>)"> 20MHz 40MHz
Control Sideband:	" onChange="updateChan_channebound(document.wlanSetup, wlan_idx);">
Channel Number:	" onChange="updateChan_selectedIndex(document.wlanSetup, wlan_idx);">
Broadcast SSID:	" onChange=""> Disabled Enabled
WMM:	" onChange=""> Disabled Enabled
Data Rate:	" onChange="checkTurboState()">
TX restrict:	" size="5" maxlength="3" value="<% getInfo("tx_restrict"); %>"> Mbps (0:no restrict)
RX restrict:	" size="5" maxlength="3" value="<% getInfo("rx_restrict"); %>"> Mbps (0:no restrict)
Associated Clients:	" onClick="showMacClick(document.wlanSetup, '/wlstatbl.htm')">
" value="ON">   Enable Mac Clone (Single Ethernet Client)
" value="ON" ONCLICK="updateRepeaterState(document.wlanSetup, wlan_idx)">   Enable Universal Repeater Mode (Acting as AP and client simultaneouly)
SSID of Extended Interface:   " size="33" maxlength="32" value="<% getInfo("repeaterSSID"); %>">
Note: If you want to change the setting for Mode and SSID, you must go to EasyConfig page to disable EasyConfig first.

<% getInfo("wlProfile_checkbox"); %> onclick="onclick_wlProfile()">   Enable Wireless Profile
Wireless Profile List: <% wlProfileTblList(); %>
      

 
   " value=0> " value=0>